iii
• Do not install by yourself. Please ask a installation professional or your dealer to install.
• This product corresponds to IP53
*1
dust and water protection standard. Do not change or damage dust or water
resistance of the product.
• Please note the dust and water resistance of this product does not guarantee damage or fault free.
CAUTION
Using with dust or water resistance degraded causes fire, electric shock, or
product damage.
This product corresponds to international standard IP rating (Ingress Protection) dust ingress protection level 5 and
water ingress protection level 3.
Terminal cover
After connecting cable etc. of the device to the terminals, check if the terminal cover is sealed correctly and closed
fi rmly using all the fi xing screws when attaching the terminal cover.
To seal the terminal cover correctly, be aware of the following points:
Check if the fi xing sealant is fi xed in the correct position in the cover. Fixing sealant is an important part to
seal the cable part.
●
The structure is to keep the airtightness
by tucking the cable pulled out along the
dent on the terminal strip base with both
fixing sealant of the terminal strip base
and terminal cover.
*1: Based on tests performed by Cosmos Corporation.
Precautions for Installation
Note:
IPX3 water resistance refers to the
capability to prevent the harmful
effects of water falling as a droplet at
any angle up to 60 degrees from the
vertical.
Terminal part on
main unit rear side
Fixing sealant
Fixing sealant
Terminal cover rear side
Fixing sealant
Stick the cable to the shape of the dent on the terminal strip base tightly.
To Next Page
Loading...
