23
3. For leaving the plasma panel from the front frame, pull the
bottom of the cabinet assy forward, lift, and remove.
4. Remove the spacers and spacer rings (×6 ).
Caution:
• Please confirm the installation place of BC hook (L, R)
Spacer and Spacer Ring when you exchange the Plasma
panel, and install BC hook (L, R) Spacer and Spacer Ring in
an original installation place after exchanging the Plasma
panel.
7.20. Remove the S-Board
1. Remove the Cabinet assy. (See section 7.19.)
2. Disconnect the connector (S1).
3. Remove the screws (×2 ) and remove the S-Board
metal frame.
4. Remove the screws (×2 ) and remove the S-Board.
To Next Page
Loading...
