Panasonic TH-65EQ1W - Page 40

40
English
[H-position] Adjust the horizontal position with .
[H-size] Adjust the horizontal size with
.
[V-position] Adjust the vertical position with .
[V-size] Adjust the vertical size with .
[Clock
phase]
(For PC IN input)
In some cases, frame of the screen
appears blurred or smudged, when PC
signal is input.
[Dot clock] (For PC IN input)
Periodic striped pattern interference
(noise) may occur when a striped pattern
is displayed. If this happens, adjust so that
any such noise is minimized.
[Over scan] Turn image over scan On/Off.
[On] [Off]
Note
●
This is enabled when the screen mode
is set to [Full], [Zoom1] or [Zoom2].
Note this setting is disabled when using
USB / MEMORY VIEWER input, multi
display or digital zoom.
[PC auto
setting]
Sets the operational mode of the automatic
position adjustment in the [Position] menu.
[Off]:
Automatic position adjustment starts when
<AUTO SETUP> is pressed on the remote
control or automatic position adjustment is
executed from the [Position] menu.
[On]:
Other than remote control or menu
operation, automatic position adjustment
starts:
●
When the display power is turned ON.
●
When the input signal is switched.
Note
●
In some cases, noise appears outside the area
picture is displayed, but it is not a malfunction.
●
[Clock phase] and [Dot clock] are enabled only when
[PC input mode] is set to [PC] in PC IN input.