59
English
●
[Changing delay] is the function to prevent the
accidental input switch during a short period,
such as when the signal is interrupted due to the
frequency change for the input signal while [Input
detection] is operating.
If a signal is detected again within the set period
(sec.), the input is not switched.
Onscreen display
Set to display / hide the following Onscreen display.
●
Power on display
●
Input signal switch display
●
No signal display
●
No external media display (at USB input)
●
MUTE display after displaying the menu screen
●
MUTE and off timer remaining time display after
<RECALL> is pressed
●
Off timer remaining time display when 3 minutes
remaining
[On]:
Displays the Onscreen display.
[Off]:
Hides the Onscreen display.
Initial input
Adjusts the input signal when the unit is turned on.
[Off] / [HDMI1] / [HDMI2] / [DVI-D] / [PC] / [VIDEO]
/ [USB]
Note
This menu is available only when [Input lock] is [Off].
(see page 59)
Initial VOL level
Adjusts the sound volume level when the unit is turned
on.
[Off]:
It will be the sound volume level which had been
set before the power of the unit was turned off.
[On]:
Sets your preferred volume.
●
Outputs with the set volume when [Initial VOL level] in
[On] state is selected on the menu.
■ To adjust sound volume level
Press <VOL +> <VOL ->.
Note
●
When [Maximum VOL level] is [On], the volume
cannot be set to the level higher than the level set for
[Maximum VOL level].
Maximum VOL level
Adjusts the maximum volume.
[Off]:
The sound volume level can be set up to 100
(maximum).
[On]:
The sound volume level will not exceed the set
point.
●
Outputs with the set volume when [Maximum VOL
level] in [On] state is selected on the menu.
■ To adjust sound volume level
Press <VOL +> <VOL ->.
Note
●
When the [Maximum VOL level] is switched from
[Off] to [On], if the [Maximum VOL level] is set lower
than the [Initial VOL level], the [Initial VOL level]
automatically becomes the same as the [Maximum
VOL level].
Input lock
Locks the input switch operation.
[Off] / [HDMI1] / [HDMI2] / [DVI-D] / [PC] / [VIDEO]
/ [USB]
Note
●
Input switch can be used when this is set to [Off].
To Next Page
Loading...
