TH-L32C10S
26
9 Measurements and Adjustments
9.1. Voltage Chart of A Board
Set A-Board to a dummy set and check the satisfaction with the specified voltage as following table.
9.2. Voltage Chart of P Board
Set P-Board to a dummy set and check the satisfaction with the specified voltage as following table.
After inspection, discharge the C7218 with 1kΩ resistor for 0.3 sec. or more.
9.3. Target of White Balance adjustment value
Clearance
x, y : +/-0.005 in Cool Colour Balance, +/-0.010 in Warm/Normal Colour Balance
Power Supply Name Measurement Point
Specification (V)
TNP4G460 / TNP4G461
SUB1.2V TP5602 1.22 - 1.32
SUB1.8V TP5601 1.78 - 1.91
SUB3.3V TP5600 3.21 - 3.45
SUB9V TP5409 8.76 - 9.45
SUB5V TP5405 4.82 - 5.18
BT30V TP5482 29.3 - 31.5
Power Supply name Measurement Point Normal condition (V) Standby condition (V)
AUDIO_VCC TP866 17.0 ± 1.7 < 3.0
12V TP865 12.0 ± 0.6 < 1.0
5VS TP854 5.6 ± 0.3 5.6 ± 0.3
STBY_6V TP853 5.6 ± 0.3 5.6 ± 0.3
PFC Vout TP801 400 ± 10 NO CARE
Ambient Temp. Colour Balance
White Gray
x y Y (cd/m2) x y Y (cd/m2)
22.5 - 27.5 deg.
Cool 0.271 0.275
>300
0.271 0.275
Don’t CareNormal 0.284 0.297 0.284 0.297
Warm 0.314 0.324 0.314 0.324
To Next Page
Loading...
