37
8.2.26. Remove the C3-Board
1. Unlock the cable clampers to free the cable.
2. Remove the DD-Heat-sink fastening screws (×10 ).
3. Remove the DD-Heat-sink (×5).
4. Disconnect the flexible cables (CB11, CB12, CB13, CB14
and CB15).
5. Disconnect the flexible cable (C36).
6. Disconnect the connectors (C33 and C35).
7. Remove the screws (×4 ) and remove the C3-Board.
8.2.27. Remove the Barrier
1. Remove the Print Circuit Board.
2. Remove the Barriers.
8.2.28. Remove the Control button
1. Disconnect the flexible cable (J1). (See section 8.2.17.)
2. Remove the screws (×11 ).
3. Remove the Cabinet bottom.
4. Remove the Control button.
8.2.29. Remove the Corner metal
1. Remove the screws (×3 each).
2. Remove the Corner metal (LT, RT).
3. Remove the screws (×3 each) and remove the screw
(×1 each).
4. Remove the Corner metal (LB, RB).
8.2.30. Remove the Cabinet assy from the
Plasma panel.
1. Place the Cabinet assy on a flat surface of a table (cov-
ered by a soft cloth) and a cushion.
To Next Page
Loading...
