9
Names of the Parts and Steps to Take Before Operation
Steps to take before operation
Operation (see pages 34 to 36)
▼
Run purified water through the Alkaline
Ionizer for about 3 or 4 minutes
(to expel the air inside the main unit)
The water quality indicator lamp blinks for
about 10 - 40 seconds.
Measuring the pH level (ion concentration)
(see pages 26 and 27)
7
5
Installing the Alkaline Ionizer
(see pages 18 to 21)
3
Attaching the bypass
selector
(see pages 12 to 17)
2
Connect the power plug
to the power outlet
(see page 21)
4
Checking the faucet
(see page 11)
1
Check that no water is leaking and also
that water is coming out of the main spout
and drain hose (see pages 24 and 25)
6
Hose strap
Water supply hose
(length: approx. 90 cm)
Faucet
(not included)
Main unit
Control panel
(see page 32)
Main spoutBypass selector
Drain hose
(length: approx. 60 cm)
Suction disc
Power cord
(length: approx. 3 m)
Power plug
Outlet pipe
(length: approx. 40 cm)
Cap
ZGS0TKAS400EXZ.indb 9ZGS0TKAS400EXZ.indb 9 5/11/2010 3:28:39 PM5/11/2010 3:28:39 PM
To Next Page
Loading...
