Panasonic TU-Z100U - Page 33

33
8.2.10. Remove the PB-Board
1. Unlock the cable clampers to free the cable.
2. Disconnect the connectors (PB1, PB2, PB3, PB4, PB5
and PB6).
3. Remove the screws (×4 ) and remove the PB-Board.
8.2.11. Remove the GH-Board
1. Unlock the cable clampers to free the cable.
2. Disconnect the connectors (GH10 and GH11).
3. Remove the screws (×4 ) and remove the GH-Board.
4. Remove the screws (×2 ) and remove the HDMI shield
metal.
8.2.12. Remove the DA-Board
1. Unlock the cable clampers to free the cable.
2. Disconnect the connectors (DA1, DA3, DA4, DA6, DA10,
DA11, DA30 and DA52).
3. Disconnect the flexible cables (DA20, DA31 and DA32).
4. Remove the screws (×7 ) and remove the DA-Board.
5. Remove the screws (×2 ) and remove the Partition
DA-Board.
8.2.13. Remove the S-Board
1. Remove the Bottom plate (L). (See section 8.2.5.)
2. Disconnect the connector (S1).
3. Remove the screws (×2 ) and remove the S-Board.
8.2.14. Remove the KA-Board
1. Remove the Bottom plate (C). (See section 8.2.5.)
2. Disconnect the connector (KA1).
3. Remove the screws (×2 ) and remove the KA-Board.