Panasonic TU-Z100U - Page 34

34
8.2.15. Remove the SG-Board
1. Remove the Bottom plate (C). (See section 8.2.5.)
2. Remove the screws (×2 ) and remove the SG-Board
unit.
3. Remove the screw (×1 ).
4. Remove the claws (×2 ).
5. Disconnect the connector (SG52).
6. Remove the SG-Board from SG-Board bracket.
8.2.16. Remove the GL-Board
1. Remove the Bottom plate (C). (See section 8.2.5.)
2. Disconnect the connector (GL02).
3. Remove the screws (×2 ) and remove the GL-Board.
8.2.17. Remove the J-Board
1. Remove the Bottom plate (R). (See section 8.2.5.)
2. Disconnect the flexible cable (J1).
3. Disconnect the connector (J2).
4. Remove the claws (×2 ) and remove the J-Board.
8.2.18. Remove the SP connector edge
cover (L, R)
1. Disconnect the connectors (SPL and SPR).
2. Remove the screw (×1 ) and remove the SP connector
edge cover (L, R).