Panasonic TU-Z100U - Page 35

35
8.2.19. Remove the SU-Board
1. Remove the screws (×2 ).
2. Remove the Partition SU-Board.
3. Remove the flexible cables (SU1B, SU2B, SU3B, SU4B
and SU5B) connected to the SU-Board.
4. Remove the flexible cable (SU11-SD11) and the bridge
connector (SC41-SU41).
5. Remove the molding prop (×1 ).
6. Remove the screws (×2 ) and remove the SU-Board.
8.2.20. Remove the SD-Board
1. Remove the flexible cables (SD1B, SD2B, SD3B, SD4B
and SD5B) connected to the SD-Board.
2. Remove the flexible cable (SU11-SD11) and the bridge
connectors (SC42-SD42 and SC46-SD46).
3. Remove the molding prop (×1 ).
4. Remove the screws (×2 , ×2 ) and remove the SD-
Board.
8.2.21. Remove the SC-Board
1. Remove the SU-Board and SD-Board. (See section
8.2.19 and 8.2.20.)
2. Unlock the cable clampers to free the cable.
3. Disconnect the connector (SC2).
4. Disconnect the flexible cable (SC20).
5. Remove the screws (×9 ) and remove the SC-Board.