Manual tuning
02 99:21 41
Store
Search
Exit
Return
Prog. +
Prog. -
C / 0 - 9 Direct entry
16
Tuning menu – Manual tuning
Press the MENU button.
Move to choose Setup menu.
Access Setup menu.
Move to choose Tuning menu.
Access Tuning menu.
Move to choose Manual tuning.
Access Manual tuning.
Select the programme position to be tuned.
Press repeatedly until required station is found.
When the desired station is found, press the OK button to store.
The programme position will flash.
Press the EXIT button at any time to go back to watching TV.
It is also possible to use the control panel buttons on the top of your TV to tune individual programme positions:
Press the F button until Tuning mode is reached.
Press the –/ or +/ button to access Tuning mode.
Press the TV/AV button to move between Change
programme, Search and Change TV system.
Press the –/ or +/ button to change programme position
or start search.
When the desired station is found, press the STR button
to store.
The programme position will flash.
Repeat above procedure to tune additional programme
positions.
Press the F button at any time to go back to watch ing TV.
Note:
If your VCR is connected to this TV by an RF cable only, choose programme position “0” to tune to the VCR
signals.
Manual tuning (via top panel)
It is possible to retune individual programme positions:
TV
OK
123
456
789
C
0
N
MENU
EXIT
OK
1
CH12
SC1
Manual tuning
+,- : Search
TV/AV : Move cursor
STR : To store
F : To Exit
02 99:21 41
To Next Page
Loading...
