Panasonic TX-24CS500B - Aspect Control Signal

Aspect Control Signal
Programmes usually contain an “Aspect Control Signal”. (Widescreen signal,
Control signal through SCART / HDMI terminal)
In Auto mode, aspect mode will appear in the top left of the screen if a
Widescreen signal (WSS) or a Control signal through SCART (pin8) / HDMI
terminal is found. The aspect switches to the appropriate ratio.
Watching > For best picture > Aspect
■ Available conditions
●
Terrestrial terminal (WSS only)
Valid input signal format:
DVB
PAL I
Invalid input signal format:
PAL 525/60 6.0 MHz
M.NTSC 6.0 MHz
●
AV1 (SCART) terminal / AV2 (VIDEO) terminals
Valid input signal format:
PAL
PAL 525/60
M.NTSC
NTSC
: Control signal through SCART (pin 8) / HDMI terminal only
●
AV2 (COMPONENT) terminals (WSS only)
Valid input signal format:
625 (576) / 50i, 50p
Invalid input signal format:
525 (480) / 60i, 60p
750 (720) / 60p, 50p
1 125 (1 080) / 60i, 50i
- 49 -