■ Analogue
Set Analogue channel manually after Auto Setup.
●
Set Sound System and Colour System, and then perform this function.
Normally set Colour System to Auto.
– SC1: PAL B, G, H / SECAM B, G
– SC2: PAL I
– SC3: PAL D, K / SECAM D, K
– F: SECAM L, L’
1. Select the channel position with Numeric buttons.
2. Select the channel with Channel Up / Down.
3. Set Manual Tuning.
4. Select Store and press OK to set.
●
Use Fine Tuning to make small adjustments to the tuning of an individual
programme (affected by weather conditions, etc.).
●
If a VCR is connected only with the RF cable, select channel position 0.
■ DVB-via-IP (DVB-S)
●
Please consult the received satellite broadcasting companies for the
setting.
1. Select Transponder Frequency / Symbol Rate / Polarisation / Modulation /
FEC / Service ID and set with Cursor buttons or Numeric buttons.
2. Select Start scan and press OK to search.
- 118 -
To Next Page
Loading...
