Panasonic UB-5825

Optional Wall-mounting Kit (KX-B063)
20
■ Wall-mounting procedure
1
Confirm that the wall is strong enough to support the weight of the electronic board.
The wall must be capable of supporting at least
1,765N [180 kgf (397 lbs.)] for UB-5325
1,912N [195 kgf (430 lbs.)] for UB-5825.
2
Tape the Wall-mounting template on the wall.
• Do not use the template included in the wall-mounting kit (KX-B063), but rather the one included with
the electronic board (UB-5325 / UB-5825).
• When taping the template on the wall, make sure it is level.
3
1) Drill holes in the wall for the wall-mounting fixtures (8 holes total).
• Holes on the wall-mounting fixture are 7 mm (
1
/4") in diameter.
2) After removing the wall-mounting template, attach the wall-mounting fixtures
with the appropriate wall-mounting hardware (two screws in each fixture).
* This hardware must be locally procured, it is not included in the kit.
• Refer to the section “Attaching the wall-mounting fixtures” on page 21 for drilling in the wall and attaching
the mounting fixtures.
4
Assemble and install the electronic board.
Refer to page 4.
Caution
Wall-mounting
fixture L
Wall-mounting template
(provided with UB-5325 / UB-5825)
Wall-mounting
hardware*
Wall-mounting
hardware*
Wall-mounting
fixture R
812.8 m
m
(
2'
8")
4
8
0mm(
1
'
6
29
/
32
"
)
50 mm
(
1
31
/32"
)
70 mm
(2
3
/
4
")
2
1
Wall-mounting
fixture L
1
406.4 mm
(16
")
Center of the
electronic board
(See page 3.)
UB-5325_IM_EN.book 20 ページ ２００８年１月８日 火曜日 午後５時７分