Recording
Manual recording functions
60
LSQT1048
Select [ ] mode, fill the screen with a white subject
and then move the joystick up to select [ ].
When the [ ] display changes from flashing to on, setting is complete.
≥ When the [ ] display continues flashing green, the white balance
cannot be set because the place is dark etc. In this case, use the
automatic white balance.
∫ About the white balance sensor A
The white balance sensor detects the type of light source during
recording.
Do not cover the white balance sensor during recording, or it may
not function properly.
≥ When the [ ] display flashes white, the manual
white balance previously adjusted is stored.
Whenever recording conditions change, re-set the
white balance for correct adjustment.
≥ When the unit is turned on with the lens cap fitted,
the automatic white balance adjustment may not
function properly. Please turn the unit on after
removing the lens cap.
≥ When setting both the white balance and the iris/
gain, set the white balance first.
To set the white balance manually
MNL
A
LSQT1048(ENG).book 60 ページ ２００６年２月６日 月曜日 午後２時１３分
To Next Page
Loading...
