Panasonic VDR-D150EB - Page 101

14.Removal of CCD P.C.B., Filter Rubber and Optical Filter
CAUTION:
1) When removing the CCD P.C.B., take care that the
Optical Filter does not fall out.
2) Use extreme caution when removing the CCD P.C.B.
as it is easily damaged by static electricity. Use a Wrist
Strap while removing and installing.
3) Do not touch the CCD window surface.
Installation of CCD P.C.B., Filter Rubber and Optical
Filter
Install in order shown below.
1) Install the Optical Filter correctly.
Note: Make sure that no dust gets on the Optical Filter
or in the Lens Unit. Clean the Optical Filter with lens
cleaning paper dampened with lens cleaner if
necessary.
2) Install the Filter Rubber on the Optical Filter correctly as
shown below.
Note: Make sure that no dust gets on the Filter Rubber.
3) Install the CCD P.C.B. into the Lens Unit. Then, tighten
the 2 Screws (536), and secure the CCD F.P.C. on the
pin.
Note: Do not touch the Lens Surface. Clean the surface
with lens cleaning paper dampened with lens cleaner
if necessary.
15.Installation of Zoom Motor Unit/Focus Motor Unit
Install the Zoom Motor Unit/Focus Motor Unit so that the
Shaft of the Zoom Motor Unit/Focus Motor Unit is set in the
Holder.
Focus
Motor
Unit
Zoom
Motor
Unit
shaft
shaft
holder
holder
pin
pin
Fig. D14
16.Removal of EVF Unit
1) Remove the 2 Screws (433).
2) Slide to extend the EVF Unit.
3) Push to release the Locking Tab (L-1), and remove the
EVF Unit. Take care not to damage the EVF F.P.C.
EVF F.P.C
Rear Case
Unit
EVF Unit
(L-1)
Slide Push
Fig. D15