Panasonic VDR-D150EB - Page 102

18.Removal of Eye Cap
1) Remove the 2 Screws (533).
2) Remove the Eye Cap, then release the Locking Tab (L-
2).
Handling cautions of EVF Lens Unit
Use extreme care when handling the EVF Lens Unit to
avoid damage, dust, and spots (especially fingerprints,
etc.)
Installation of EVF Lens Unit, Eye Sight Lever
1) Install the Eye Sight Lever into the EVF Case in the
direction shown.
2) Install the EVF Lens Unit fitting both ribs into the EVF.
3) After installing, confirm that the Eye Sight Lever and
EVF Lens Unit work together correctly.
Eye Sight Lever
EVF Case
ribs
ribs
EVF Lens Unit
Fig. D17
17.Installation of EVF Base Frame, EVF F.P.C.
1) Pass the EVF F.P.C. through the EVF Base Frame hole.
2) Connect the EVF F.P.C. to Connector FP901.
3) Install the EVF Case Ass'y into EVF Base Frame so that
the ribs are inserted into the slots of the EVF Base
Frame.
4) After installing, confirm the EVF moves correctly.
slot
EVF Base Frame & EVF Earth Plate
EVF Case Ass'y
EVF F.P.C.
rib
rib
FP901
slot
Fig. D16