Notes in chart
1. Removal of Top Cover Unit
1) Open the LCD and remove the 5 Screws (533).
2) Slide the EVF to extend it, then remove Screw (519).
3) Pull and carefully slide the Top Cover Unit.
Slide
Open
Slide
Top
Cover
Unit
519
533
533
533
533
533
Fig. D1
2. Removal of Front Case Ass'y
1) Open the Jack Cover, then remove Screw (519).
2) Remove the 4 Screws (519, 533).
3) Disconnect the Front F.P.C. from Connector FP2.
4) Remove the Front Case Ass'y while releasing the Hand
Strap.
<Front View>
Jack Cover
FP2
Hand Strap
519
519
533
519
533
Fig. D2
3. Installation of Side R & LCD Ass’y
1) Connect the LCD F.P.C. and Side R F.P.C. to the
Connectors FP4 and FP1 so as not to damage the
F.P.C.s.
2) Secure Rear Portion, and tighten 6 Screws (519, 533)
Side R & LCD Ass’y
FP4
FP1
Rear Portion
Curve to the inside
519
533
533
533
519519
Fig. D3
To Next Page
Loading...
