Auto channel setup (ANT/Cable setup)
Select the connected Antenna in terminal
Not used: Go to Q
(Labelinputs)
Select "Not used" when no wire is connected to the "Antenna/Cable" terminal.
® Typical when a Cable/Satellite box is connected to a TV input.
® Prevents accidental tuning to an unavailable signal.
<2_Select "Start"
Skip: Go to
(Labelinputs)
Start scanning the channels
(Available channels are automatically set.)
@
"-m
-7"
_-ft.
B
O_
C
7D
• Press to return to
the previous screen
RETURN
® About broadcasting
systems
Analog (NTSC):
Conventional
broadcasting
Digital (ATSC):
New
programming
that allows
you to view
more channels
featuring
high-quality
video and sound
Complete the Auto program setup
Completion message is displayed when the Auto program scan is successfully completed.
If there is no available
OK channel, return to @- _1)
(ANT/Cable setup).
"Not used" will be selected.
Select the Input labels (Label inputs)
Select NEXT then press OK to go to the next step.
or
Follow the instructions on
screen to complete the
following operations.
Label: [BLANK] Not used/Blu-ray/DVD/DVD REC/HOME THTR/GAME/COMPUTER/
VCR/CABLE/SATELLITE/DVR/CAMERA/MONITOR/AUX/RECEIVER/MEDIA
CTR/MEDIA EXT/OTHER
• Operation of the EXIT button during "First time setup"
Press the button once to display confirmation screen. Press again to close
confirmation screen.
[EXIT confirmation screen]
Yes @ Exit "First time setup"
No @ Return to the original screen.
15
To Next Page
Loading...
