First Time Setup (Continued)
Configure Network settings
0) Select the Network type
Set later: Go to O
You can set in "Setup" menu later.
Wireless (WiFi): Start "Wireless network" (p. 17)
{2) Select the setting mode Automatic: Press OK to start setup automatically,
Error screen is displayed when
Network connection has failed.
Manual: Go to Manual setting,
IAut°matic I 6
Start connection test
[ Connection test[
Connection
@ Complete "Network settings"
Helpful information is displayed when you
successfully complete "Network settings".
• Manual setting
• Error screen
16
• Press to return to
the previous screen
RETURN
Retry: Go to "Start connection test"
Set later: Go to O
• About wireless LAN
® Wireless LAN adapter and Access point need to be obtained separately.
For the latest information on applicable LAN adapters, check the following website:
http:llpanasonic.jplsupportlgloballcsltvl
® Check that the Access point supports WPS%
(Ifit doesnot supportWPS,theencryptionkeyofthe Accesspointisrequiredwhen configuringsettings.)
® Followtheinstructionsonthe Accesspointsetupscreenand configurethe appropriatesecuritysettings.
Formoredetailson settingofAccesspoint,pleaserefertooperatingmanualfortheAccesspoint.
® We recommend using 11n (5 G Hz) for the wireless system between the wireless
LAN adapter and Access point.
Communication is also possible with 11a, 11b, and 11g (2.4 GHz), but the
communication speed may be slower.
® If the wireless system of the Access point is changed, devices that could connect by
wireless LAN may no longer be able to connect.
® When VlERA CAST, or other device is using the network, do not disconnect the
wireless LAN adapter.
® Keep the TV away from the following devices as much as possible:
Wireless LAN, Microwaves, and other devices that use 2.4 GHz and 5 GHz signals.
Otherwise, the TV failures such as malfunction may occur due to the radio wave interference.
WPS: Wi-Fi Protected Setup
To Next Page
Loading...
