• Assembling the pedestal
insert the protrusion of the Neck
into the Base firmly.
-- Neck
of the
Neck (bottom)
_, !i!i!iiiii_
Front
(_ Attach the BrackettotheprotrusionofNeck.
Makesurethat the bracketis anchored
beforefixingthe screws.
Fixsecurelywith assemblyscrews.(4 screws)
Turn the stand over and fix stand neck
securely with assembly screws.
(for 50": 3 screws, for 55": 4 screws)
• Donothotdtheneckwhenturningover thestand.
F _,
BjJx 3 pcs. (for 50")
pcs. (for 55")
[TC=PSOGTSO]
Back of Stand
[TC-P55GTS0]
@ Attach the cover and fix securely with
assembly screw.
x 1 pcs.
reSet-up
¢ Tighten assembly screws @ (total 4 screws) loosely at first,
then tighten them firmly to fix securely.
Rear side
Accessories
Assembly screws
® XYN4+F10FNK (Black)
size (M4 x 10)
(for 50" (5), for 55" (1))
® XYN5+F16FN (silver)
size (M5 x 16)
(for 50" (7), for 55" (12))
Bracket (1)
® TBL5ZA3254 (for 50")
® TBL5ZA3200 (for 55")
Neck (1)
® TXFBL5Z0083 (for 50")
_£_TXFBL5Z0086 (for 55")
@
Cover (1)
® TXFBL5Z0091 (for 50")
(® TXFBL5Z0056 (for 55")
® Cover is in the same bag
with Owner's Manual
Base (1)
<_TBL5ZX0313 (for 50")
@ TBL5ZX0328 (for 55")
Hole for pedestal
installation
) x 4 pcs. (for 50")
) x 4 pcs. (for 55")
Bracket
Base /
(Image) [Work on a flat surface]
( Warning )
Do not disassemble or modify the pedestal.
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when
using the wall hanging bracket or repacking the TV.
_1_Remove the assembly screws @ (for 50")/_B_(for 55")
from the TV.
@_Lift the TV from the pedestal.
Remove the assembly screw _A_from the cover.
{4} Pull out the cover.
{5} Remove the assembly screws _B_from the Bracket.
{6} Remove the assembly screws _B_from the Back of
stand and pull out the neck.
® Otherwise, the TV may fall over and become damaged, and personal injury may result.
Caution )
Do not use any pedestal other than that provided with this TV.
® Otherwise, the TV may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
® If you use the pedestal when it is physically damaged, personal injury may result.Contact your nearest Panasonic Dealer immediately.
During set-up, make sure that all screws are securely tightened.
® If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong
enough to support the TV, and it might fall over and become damaged, and personal injury may result.
When removing the pedestal, do not remove the pedestal by any methods other than the specified procedure, (Above)
_ Otherwise, the TV and/or pedestal may fall over and become damaged, and personal injury may result.
9
To Next Page
Loading...
