SD
CARD
8
Identifying Controls
TV
Power LED
Standby: red
On: green
When using the remote control, indicates the TV has received a command.
Changes the input mode
Function select
Volume / Contrast / Brightness / Colour /
Sharpness / Tint (NTSC mode) / Bass / Treble /
Balance / Auto Setup (p. 34 and p. 35)
Mains power On / Off switch
Switch On to turn on the TV or turn the TV to standby
mode by the remote control
Remote control signal receiver
Do not place any objects between the TV remote control signal receiver and
remote control.
Timer LED
Active for Timer Programming or
Standby for Direct TV Recording: orange (flash)
Timer Programming On: orange
C.A.T.S. (Contrast Automatic Tracking System) sensor
Senses brightness to adjust picture quality when “Eco Mode” in the Picture Menu
is set to “On” (p. 30)
SD Card slot
(p. 50)
CI slot (p. 45)
Headphones
jack
(p. 61)
Increases or decreases the channel
position by one. When a function is
already displayed, press to increase or
decrease the selected function.
When in Standby mode, switches TV On.
Auto power standby function
If no signal is received and no operation is performed in Analogue TV mode for 30 minutes, the TV will
automatically go to standby mode
To Next Page
Loading...
Need help?
General