Tuning and Editing Channels (DVB)
53
Update DVB channel automatically [Update Channel List]
Y ou can add new channels, delete removed channels, update channel name and position automatically to Channel List.
CH 5 69
Searching
DVB-T Update Channel List
Progress
T his will take about 3 minute
s.
CH Channel Name Type Quality
Free TV: 0 Pay TV: 0 Radio: 0
•
C hannel List is updated while keeping your settings in [Favourites Edit],
[Channel List], [Child Lock], etc.
•
D epending on the signal condition, the update may not work properly.
•
T o update DVB-S channels, the satellite, search mode and scan mode settings
are required before updating.
Astra 19.2° E
Satellite
Quick
Search Mode
Scan Mode
DVB-S Update Channel List Settings
Free Channels
Start scan
access / store
select
•
After settings, select [Start scan].
Display a notification message [New Channel Message]
Selects whether to give a notification message when a new DVB channel is found. [Off] / [On]
New channels found!
Press OK to update channel list.
Press EXIT to ignore.
•
Selecting OK will perform [Update Channel List].
Check DVB signal [Signal Condition]
Selects a channel and checks the DVB signal condition.
A good Signal Strength is not an indication of suitable signal for DVB reception.
Please use the Signal Quality indicator as follows :
[Signal Quality] :
•
Green bar Good
•
Y ellow bar Poor
•
R ed bar Bad (Check the Terrestrial aerial, cable or Satellite dish)
•
T o change the channel
Example :
70 CBBC Channel
90
80
%
%
0.00E+00
Wenvoe
802,00 MHz, 64 QAM, 6940 kS/s
DVB-C Signal Condition
Signal Quality
C hannel Name
Signal Strength
B it Error Rate
N etwork Name
P arameter
T hese bars show the maximum signal value of the selected channel.
Reduce the DVB-C signal [Attenuator]
If the DVB-C signal is too strong, the interference may occur. In this case set to [On] to reduce the signal automatically.
•
T his function is available only for DVB-C signal.
To Next Page
Loading...
