Panasonic VL-SWD272 - Page 2

Specications
Model Composition
Model number and name
VL-MWD272 VL-V522L VL-WD613 VL-FKD2
Main Monitor Station (Main monitor)
Extension Monitor
Door Station (Doorphone)
Wireless Monitor Station (Sub monitor)
DECT Repeater
Main body Charger
Dimensions
(mm)
Up to 3
*1
(not including the main monitor)
Up to 2
Up to 6
*1
Up to 2
Power source 220-240 V AC, 50/60 Hz Power supplied by the main monitor Rechargeable Ni-MH (AAA x 2)
AC adaptor (PNLV226)
Input: 220-240 V AC, 0.1 A, 50/60 Hz
Output: 5.5 V DC, 0.5 A
AC adaptor (PQLV219)
Input: 220-240 V AC, 0.1 A, 50/60 Hz
Output: 6.5 V DC, 0.5 A
Power consumption
Standby: Approx. 2.5 W
During operation: Approx. 10 W
- -
Standby: Approx. 0.4 W (when the sub
monitor is not placed in the charger)
During charging: Approx. 1.4 W
Standby: Approx. 1.5 W
During operation: Approx. 2.3 W
(when transmitting)
Dimensions (H x W x D)
(Excluding protruding sections)
158 x 243 x 29.5 mm 131 x 99 x 36.5 mm 173 x 52 x 30 mm 43 x 81 x 76 mm 82 x 111 x 39 mm
Weight 825 g
*2
200 g 160 g (including the batteries) 70 g (excluding the AC adaptor) 88 g (excluding the AC adaptor)
Operating environment
Ambient temperature: Approx. 0 °C to +40 °C
Relative humidity (non-condensing): up to 90 %
Ambient temperature: Approx. -15 °C to +55 °C
Relative humidity (non-condensing): up to 90 %
(tested up to -20 °C)
Ambient temperature: Approx. 0 °C to +40 °C
Relative humidity (non-condensing): up to 90 %
Ambient temperature: Approx. 0 °C to +40 °C
Relative humidity (non-condensing): up to 90 %
Ambient temperature: Approx. 0 °C to +40 °C
Relative humidity (non-condensing): up to 90 %
Display 7-inch wide colour / WVGA (800x480 pixels) - 2.2-inch colour / QVGA (320x240 pixels) - -
Display language English, Arabic - English, Arabic - -
Talking method Hands-free - Hands-free - -
Frequency range 1.88 GHz to 1.90 GHz - 1.88 GHz to 1.90 GHz - 1.88 GHz to 1.90 GHz
Viewing angle -
Horizontally: Approx. 87˚
Vertically: Approx. 66˚
- - -
Installation method
Wall mount
(mounting bracket supplied)
Surface mount (mounting base supplied) - - -
Minimum illuminance required -
1 lx
(within approx. 50 cm from the camera lens)
- - -
Lighting method -
Warm white coloured LED lights,
Infrared LEDs
- - -
Transmitting range - -
Approx. 100 m (line-of-sight distance
from the main monitor)
-
Approx. 100 m (line-of-sight distance
from the main monitor)
IP rating / IK rating -
IPX3
*3
- - -
External material
Flame retardant PC+ABS resin,
Flame retardant ABS resin
Flame retardant ABS resin ABS resin ABS resin PS resin
243
158
29.5
99
131
36.5
52
173
30
81
43
76
111
82
39
VL-SWD272 VL-MWD272 x 1, VL-V522L x 1, VL-WD613 x 1
VL-SVD272 VL-MWD272 x 1, VL-V522L x 1 (VL-WD613 sold separately)
Installing the Main Monitor/Extension Monitor
Installing the Doorphone
Important
– Safety Precaution: carefully read the operating instructions and installation manual before using this product.
• The actual product may vary slightly from photograph.
• Weights and dimensions are approximate.
• Design and Specifications are subject to change without notice.
• These products may be subject to export control regulations.
*1 When sub monitors and extension monitors are used together, a total of up to 6 sub monitors and extension monitors can be registered.
*2 Including AC cord. The weight of the AC cord differs depending on the region.
*3 Water resistance is only assured if the doorphone is installed correctly according to the instructions in the Installation Guide, and appropriate water protection measures are taken.
Vertical, at wall
Screws
Hole in wall
83.5 mm
60 mm
7 mm
50 mm
Mounting bracket
Wood screws
Mounting base
Wire
(User supplied)
Screwdriver
83.5 mm
Wall
Side View Top View
131 mm
99 mm
Mounting
base
24 mm
83.5 mm
Image range
Centre of
doorphone
1450 mm
650 mm
1810 mm
1160 mm
500 mm
66°
87°
500 mm
960 mm
•Installation Position
DISTRIBUTED BY :
MG-DHPL024EN 1705TD/ZZZ-2
158 mm
243 mm
Mounting bracket
Main Monitor
58 mm
83.5 mm