To Next PageTo Next PageWhy does the Panasonic Heat Pump display power consumption remain unchanged?
The display power consumption on your Panasonic Heat Pump might remain at the previous value because the memory saves data hourly, and a power failure will display the last hour's data. Also, the total power consumption may have reached 999 days, requiring you to press the reset counter.
How to improve HEAT/COOL mode efficiency on a Panasonic WH-SXC09F9E8 Heat Pump?
If your Panasonic Heat Pump's HEAT or COOL mode isn't working efficiently, make sure the temperature is set correctly, close the panel heater/cooler valve, and clear any obstructions in the air inlet and outlet vents of the outdoor unit.
Why is there a water flowing sound during Panasonic Heat Pump operation?
The water flowing sound is due to the refrigerant flow inside the unit.
Why does my Panasonic Heat Pump system switch off?
The system switches off because of the protection control. When the water inlet temperature drops below 10 °C, the compressor stops, and the backup heater turns on.
Why Panasonic WH-SXC09F9E8 Heat Pump display power consumption remains as previous value?
The display shows the previous value because the memory is saved on an hourly basis. If there's a power failure, the data from the last hour will be displayed. If the total power consumption has reached 999 days, press to reset the counter.
Why does my Panasonic WH-SXC09F9E8 Heat Pump outdoor unit emit water/steam?
The emission of water or steam is due to condensation or evaporation occurring in the pipes.
Why does Panasonic WH-SXC09F9E8 Heat Pump operation start automatically when the timer is not set?
The operation starts automatically because the sterilisation timer has been set.
Why does Panasonic WH-SXC09F9E8 Heat Pump make a loud refrigerant noise for a few minutes?
The loud noise is caused by protection control during deice operation when the outdoor temperature is lower than -10°C.
Why does Panasonic WH-SXC09F9E8 backup heater turn on automatically when it is disabled?
The backup heater turns on automatically due to the protection control of the indoor unit heat exchanger.
Why does steam come out of the Panasonic Heat Pump outdoor unit in the heating mode?
The steam is caused by the defrost operation in the heat exchanger.
General