EasyManua.ls Logo

Panasonic WV-CM2000 - Cable Informations

Panasonic WV-CM2000
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
-5-
CABLE INFORMATIONS
Power Cord
1. Keep the Power Switch (1) in the OFF position during
installation.
2. Connect the Power Cord to a grounded electrical out-
let.
Video Cable
1. Use 75-ohm coaxial cable [RG-59/U (3C-2V), RG-6/U
(5C-2V), RG-14/U (7C-2V), RG-15/U (10C-2V)]
2. Up to 10 monitors can be hooked up in this configura-
tion before signal loss occurs. Total cable length
should not exceed 150m.
3. Wiring Precautions :
Do not bend coaxial cable into a curve whose
radius is smaller than 10 times of its diameter.
Never crush or pinch the cable.
All these will change the impedance of the cable and
cause poor picture quality.
Type of RG-59/U RG-6U RG-11/U RG-15/U
coaxial cable (3C-2V) (5C-2V) (7C-2V) (10C-2V)
Recommended (ft) 825 1,650 1,980 2,640
maximum
cable length (m) 250 500 600 800

Related product manuals