O Referring to Fig. 2-1-9, remove four screws that secure
the Main Board and remove the Main Board and
disconnect one connector.
Fig. 2-1-9
2.2. Slip Ring Replacement Procedure
8 After disassembling the camera according to the "2.1
Disassembling Procedure for the Camera Head" Q -
T, carry out the following procedure.
Q Referring to Fig. 2-2-1, remove five screws and one
connector that secure the Camera Head Unit, and
remove the Camera Head Unit by pulling it up.
Fig. 2-2-1
Y Referring to Fig. 2-1-6, remove two screws that secure
the Lens Cover and remove the Lens Cover .
Fig. 2-1-6
U Referring to Fig. 2-1-7, remove one screw that secure the
Tilt Board.
Fig. 2-1-7
I Referring to Fig. 2-1-8, remove three screws that secure
the Camera Unit and remove the Camera Unit.
Fig. 2-1-8
Remove one screw.
two screws.
three screws.
Remove two screws.
one connector.
To Next Page
Loading...
