Panasonic WV-CS950

-40-
SCENE SELECT SETTING
■ Using the Scene Select Setting
Menu
Display the scene select setting menu from the setup
menu to configure scene select settings. First, display
the scene select setting menu.
1. Display the setup menu (page 21), move the cursor
to SCENE SELECT O, and then press the CAM
(SET) button.
This will display the scene select setting menu.
● Scene Select Settings
Use the following procedure to configure scene select
settings.
1. Move the cursor to SCENE, and then tilt the joystick
left or right to change the scene setup.
INDOOR (L) : Indoor setting (picture quality
priority)
INDOOR (H) : Indoor setting (sensitivity
priority)
OUTDOOR (L) : Outdoor setting (picture
quality priority)
OUTDOOR (H) : Outdoor setting (sensitivity
priority)
Note: The camera cannot be installed outside.
Settings related to the picture switch depending on
the scene settings. Scene select settings and
relationship to other settings are shown in the table
below.
2. Move the cursor to LOAD, and then press the CAM
(SET) button.
This will cause the setup you selected for SCENE in
step 1 to be applied to the image.
**SCENE SELECT**
SCENE INDOOR(L)
LOAD
RET TOP
AGC SENS UP SHUTTER BW DNR WHITE BAL
INDOOR (L) MID OFF OFF OFF LOW ATW1
INDOOR (H) HIGH ×2 AUTO OFF OFF HIGH ATW1
OUTDOOR (L) MID OFF AUTO AUTO LOW ATW2
OUTDOOR (H) HIGH ×2 AUTO AUTO AUTO HIGH ATW2
WV-CS950US05.4.278:54PMページ40
www.absolualarme.com met à la disposition du public, via www.docalarme.com, de la documentation technique dont les références, marques et logos, sont la propriété des détenteurs respectifs