Caution for Use and Maintenace
OM1105050JE03
13
2.Caution for Use and Maintenace
2.1 Caution for Use
• Welding work generates arc ray, noise, spatters and
slag. Protect yourself and others.
• Do not touch torch body and gas hose connecting metals
during welding. They are electrically charged.
Nozzle of water-cooled welding torch is also electrically
charged.
2.2 Maintenance
Use genuine Panasonic replacement parts to keep safe
and long durable operation.
♦Daily Maintenance
♦Replacement of Inner Tube
Turn nut cover and remove connector from power cable.
Pull Inner tube out of torch body.
CAUTION
Before operation, turn off all input power for welding power source, robot control-
ler and all equipment connected.
Parts Maintenance
Contact tip Check it before daily operation. Replace a large hole tip.
Nozzle Check it before daily operation. Replace a deformed nozzle.
Liner
Clean it every week. Replace a bent or deformed liner.
Inner tube Clean it with solvent. Replace a tube with deformed entrance.
Wire clamp unit
Detach the wire cramp unit from the torch, and blow high-pressure
air to the hole of the wire guide. If the refuse still remains, detach the
cylinder and clean it from the top side.
1 Torch body
2 Inner tube
3 Connector
4 Nut cover
5 Power cable
To Next Page
Loading...