P&B MPR3E5 - Mode 2 Settings

14/1/98 Page 8 Issue H
5.1.2. Mode 2 Settings.
The setting parameters may be changed in mode 2.
Data Displayed LED No/ Colour
t6x Setting 1/ Green
Full Load Current I FLC 1/ Green - Flashing
CT Primary Setting In 9/ Green - Flashing
Hot / Cold Ratio 9/ Green
Thermal O/L Pre-Alarm 1/ Green/Orange -Alternating
E/Fault Current, %In 2/ Green
Earth Fault Time 2/ Green - Flashing
NPS Current, %FLC 3/ Green
Low Set O/C, %FLC 4/ Green
Low Set O/C Time 4/ Green - Flashing
High Set O/C, %In 5/ Green
High Set O/C Time 5/ Green - Flashing
Undercurrent, %FLC 6/ Green
Undercurrent Time 6/ Green - Flashing
Number of Starts/hr 7/ Green
Start Inhibit Time 7/ Green - Flashing
Set Password 8/ Green
Serial Link Address 8/Rsnn on display
Set Trip Relay Action Tnnn on Display
Set Program. Relay Pnnn on Display
Set Alarm Relay Action Annn on Display
Set E/Fault Parameters Ennn on Display
Set Trip Reset Action Rnnn on Display
Set Thermal O/L Curve Cnnn on Display
Set Speed Switch Snnn on Display
Advanced Relay 1. Xnnn on Display
More detail on these parameter are available in the Setting Section.