P&E CYCLONE FX - SAP Verify Checksum Related Errors; SAP Verify Range and Module Related Errors; SAP User Function Related Errors; SAP Trim Related Errors

User Manual For CYCLONE FX Programmers 131
14.8 SAP Verify Checksum Related Errors
$4001: Verify Checksum not supported
$4002: VC failed, invalid algorithm was used
$4003: VC operation failed or was canceled
$4011: VV command not supported
$4012: VV failed, invalid algorithm was used
$4013: VV operation failed or was canceled
14.9 SAP Verify Range and Module Related Errors
$5003: Error during verifying module.
14.10 SAP User Function Related Errors
$6003: Error during user functions.
14.11 SAP Trim Related Errors
$7001: Program Trim operation is not supported
$7003: No target response during a Program Trim operation
$7004: Program Trim error. Trim value is not set
$7007: Program Trim error. Trim value failed
$7008: Trim error. Trim value read failed
$7009: Trim value invalid, value is $00 or $FF
$700A: Trim value is invalid. Trim value is already programmed.
14.12 Unrecoverable Fatal Errors
$8001: Fatal Error: please contact PEmicro.
$8002: Fatal Error: please contact PEmicro.
$8003: Fatal Error: please contact PEmicro.
$8004: Fatal Error: please contact PEmicro.
$8005: Fatal Error: please contact PEmicro.
$8006: Fatal Error: please contact PEmicro.
$8007: Fatal Error: please contact PEmicro.
$8008: Fatal Error: please contact PEmicro.
$8009: Fatal Error: please contact PEmicro.
$800A: Fatal Error: please contact PEmicro.
$800B: Fatal Error: please contact PEmicro.
$800C: Fatal Error: please contact PEmicro.
$800D: Fatal Error: please contact PEmicro.
$800E: Fatal Error: please contact PEmicro.
$800F: Fatal Error: please contact PEmicro.
$8010: Fatal Error: please contact PEmicro.
$8011: Fatal Error: please contact PEmicro.
$8012: Fatal Error: please contact PEmicro.
$8013: Fatal Error: please contact PEmicro.
$8014: Fatal Error: please contact PEmicro.