User Manual For CYCLONE FX Programmers 45
key on the keyboard, the image status will be changed to "Ready to Erase.” The image will be
removed after "Apply Changes" is clicked.
6.2.2 Add/Remove Images From The Commit Changes Panels
Once the images that you wish to load appear in the images tab, you must press “Apply Changes”
to update the Cyclone accordingly. No actual updates will occur to the Cyclone’s internal/external
memory or installed SD card until the user selects “Apply Changes.
Note: Any SAP images that are already stored on older Cyclone models such as the Cyclone PRO,
MAX, Renesas, STMicro or Cyclone ACP Rev. A/B (or on a CompactFlash card in one of those
units, if applicable) can not be removed individually and can only be erased by removing all
images.
To Next Page
Loading...