User Manual For CYCLONE FX Programmers 91
6 - Starting address is not in module.
7 - Ending address is not in module or is less than starting address.
8 - Unable to open file for uploading.
9 - File write error during upload.
10 - Upload canceled by user.
11 - Error opening algorithm file.
12 - Error reading algorithm file.
13 - Device did not initialize.
14 - Error loading .PCP file.
15 - Error enabling module just selected.
16 - Specified S record file not found.
17 - Insufficient buffer space specified by .PCP to hold a file S-record.
18 - Error during programming.
19 - Start address does not point into module.
20 - Error during last byte programming.
21 - Programming address no longer in module.
22 - Start address is not on an aligned word boundary.
23 - Error during last word programming.
24 - Module could not be erased.
25 - Module word not erased.
26 - Selected algorithm file does not implement byte checking.
27 - Module byte not erased.
28 - Word erase starting address must be even.
29 - Word erase ending address must be even.
30 - User parameter is not in the range.
31 - Error during algorithm-specified function.
32 - Specified port is not available or error opening port.
33 - Command is inactive for this .PCP file.
34 - Cannot enter background mode. Check connections.
35 - Not able to access processor. Try a software reset.
36 - Invalid algorithm file.
37 - Not able to access processor RAM. Try a software reset.
38 - Initialization cancelled by user.
39 - Error converting hexadecimal command number.
40 - Configuration file not specified and file prog.cfg does not exist.
41 - Algorithm file does not exist.
42 - Error in io_delay number on command line.
43 - Invalid command line parameter.
44 - Error specifying decimal delay in milliseconds.
47 - Error in script file.
49 - Cable not detected
50 - S-Record file does not contain valid data.
51 - Checksum Verification failure - S-record data does not match MCU memory.
52 - Sorting must be enabled to verify flash checksum.
To Next Page
Loading...