INOXPAN S.L. EN - 17
5.
Once the door is locked, the symbol will light up on the clock display and the time remaining before
the end of the pyrolysis will appear
6.
When the pyrolytic cleaning cycle has finished, an alarm will sound and you will see the time ‘0:00’
on the clock display.
7.
Press any of the timer’s keys to disable the alarm.
8.
Turn the control dial to the position.
9.
The oven’s heating process has finished. However, the oven is extremely hot and cannot be used.
The cooling process will continue to operate and the symbol and the symbol will remain lit until
the oven cools down
10.
Once the oven has cooled down, the symbol and the symbol will turn off.
11.
Open the oven door and wipe the inside with a damp cloth, removing the ash from the cleaning
cycle. Hard-to-reach areas in the oven will need to be cleaned with a non-metallic fibre scourer.
12.
Once the oven is clean, do not forget to replace the supports and accessories.
13.
The oven is now ready to be used.
Si la puerta no está bien cerrada, no se bloqueará, sonará una alarma y la pirólisis no comenzará.
Si esto ocurre, apague la alarma tocando cualquier tecla del reloj, cierre bien la
mando del selector de funciones en posición y vuelva seleccionar el pro
siguiendo las instrucciones anteriores.
As a result of the high temperatures inside the oven, the cooling process may vary depending
on the room temperature.
If any incident is detected in the programming or use of this function, consult the installation and
maintenance guide included with your oven.
To Next Page
Loading...
