29
USER AND INSTALLATION MANUAL
READ THE PROCEDURE FOR ENTERING THE PIN-CODE BEFORE USING EMERGENCY FUNCTIONS.
• Enter the first digit • Press the button the number of times equal to the first digit. Pauses between
presses should not exceed 1 second. Each pressing will be confirmed with an orange LED indicator
flash. Pause for more than 1 second, a red LED indicator flash confirm the input of the first digit. Then
you can enter the next digit.
• Enter the second digit • Press the button the number of times equal to the second digit. Pauses
between presses should not exceed 1 second. Each pressing will be confirmed with an orange LED
indicator flash. Pause for more than 1 second, a red LED indicator flash confirm the input of the
second digit. Then you can enter the next digit.
• Enter the third digit • Press the button the number of times equal to the third digit. Pauses between
presses should not exceed 1 second. Each pressing will be confirmed with an orange LED indicator
flash. Pause for more than 1 second, a red LED indicator flash confirm the input of the third digit.
Then you can enter the next digit.
• Enter the fourth digit • Press the button the number of times equal to the fourth digit. Pauses
between presses should not exceed 1 second. Each pressing will be confirmed with an orange
LED indicator flash. The correct input will be confirmed with the series of green and red flashes
of the LED indicator.
Emergency disarming
Not paying attention to the siren signals, make sure that the ignition is off and enter the «Secret PIN-
code» (see the procedure description above). If there are no siren sounds or LED flashes, check the
battery. It is not possible to enter the «Secret PIN-code», if there is no power supply.
• The system will be disarmed in case of correct PIN-code input. It will be confirmed with the series of
green and red flashes of the LED indicator, the series of sound signals of the Beeper, 4 beeps of the
Siren and 4 signals of the light signalization.
• Emergency disarming is equivalent to a normal method of disarming. No additional actions are
required for further operation of the system.
• The system will stay in previous state in case of incorrect input of the PIN-code. It will be indicated
with a long red flash of the LED indicator. New input can be attempted after 5 seconds.
To Next Page
