Pandora Mini Moto - Emergency Control of the Code Immobiliser

30
PANDORA MINI MOTO
Emergency control of the Code Immobiliser
This section describes two options to deactivate Immobiliser modes:
• Immobiliser and Anti-hi-Jack - use owner authorization devices (tags, remotes, watches, bands) for
engine blocking;
• Code Immobiliser - uses standard vehicle controls (buttons, levers, pedals) to enter the Immobiliser
PIN-code.
OPTION №1 – Emergency deactivation of the Code Immobiliser
To temporarily deactivate the Code Immobiliser (pin-to-drive) function, turn on the ignition when the system
is disarmed and Service mode disabled. Enter the «Secret PIN-code» from the Owner’s personal card using
the VALE T button. The Immobiliser functions will be deactivated by the time the ignition is turned off.
OPTION №2 – Emergency control of the Code Immobiliser mode
This method is used for a permanent deactivation of the Code Immobiliser (pin-to-drive) function.
Deactivation and activation is made by entering the «Secret PIN-code» from the owner’s personal card
using the VALET button while system is disarmed, ignition is off and the Service mode is disabled.
1. Enter the programming mode by entering the «Secret PIN-code» (from the Owner’s personal
card) or the «Service PIN-code» (factory preset is 1-1-1-1). The PIN-code should be entered using the
external or located on the base unit VALET button.
3. o deactivate the function – The LED indicator will be green after entering the programming level.
The system will wait 10 seconds for entering the «Secret PIN-code». If the PIN-code is not entered within 10
seconds or the input is incorrect, the LED will produce the series of red and green flashes and the system
will return to the programming menu. Enter the «Secret PIN-code» that is written on the Owner’s personal
card. The system will confirm deactivating with a long red LED flash and two sound signals of the Siren.
Turn on the ignition and then turn off to exit programming mode. The function will be deactivated.
4. To activate the function – The LED indicator will light red after entering the programming level.
The system will wait for action. Press the VALET button once to activate the function. The system will
confirm enabling with one short sound signal of the Siren and a green LED light. Turn on the ignition
and then turn off to exit programming mode. The function will be activated
2. Code Immobiliser еnter the programming
level №13 - press the VALET button 13 times
(without pauses).
2. Immobiliser / Anti-Hi-Jack – enter the
programming level №15 - press the VALET button
15 times (without pauses).