Pandora Mini Moto - Level №4 - Reset to the Factory Settings; Level №10 - Manage Bluetooth Devices; Firmware Update

36
PANDORA MINI MOTO
Level 4 – Reset to the factory settings
The procedure recovers the factory settings of the system without deleting previously registered
devices (tags, mobile device, relays, etc.) that is stored in the non-volatile memory.
Enter the programming level №4:
• Press and hold the VALET button for more than 4 seconds. Release the button after a sound of the
Siren. The system will confirm the resetting to the factory settings with a long red flash of the LED
indicator. After that, the system will reset the settings to default and return to the programming
level №0.
Level 10 – Manage Bluetooth devices / Firmware Update
!
all addiTiONal dEvicEs iNcludEd iN ThE sysTEm sET arE pairEd wiTh ThE sysTEm. ThE maximum NumbEr Of pairEd
bluETOOTh dEvicEs musT NOT ExcEEd 14.
all fuNcTiONs Of This lEvEl arE availablE iN ThE paNdOra spEcialisT app whEN usiNg a bluETOOTh cONNEcTiON.
fOr ThE maNagEmENT Of ThE addiTiONal dEvicEs gO TO «advaNcEd mOuNTiNg» -> «pairiNg/uNpairiNg dEvicEs».
fOr ThE firmwarE updaTE Of ThE addiTiONal dEvicEs gO TO «advaNcEd mOuNTiNg» -> «sysTEm dEvicEs».
fOr a dETailEd dEscripTiON Of pairiNg prOcEdurE fOr spEcific dEvicE chEck iT’s maNual ON www.paNdOraiNfO.cOm.
This level is used to pair/remove/update additional devices of the system. Each device is paired at
a sublevel. To pair devices of the same type, a sublevel is divided into cells. To enter a sublevel or a
cell of sublevel make a pause for more than 1 second, then press (P) the VALET button the number of
times equals to the desired sublevel or cell number: «Level №10» (1sec) «Sublevel 1…10» (1sec) «Cell
of sublevel 1…4».
PAIRING/DELETING AN ADDITIONAL DEVICE
Each sublevel or cell displays it’s current state by a color of the LED: green light means the system is
ready for pairing, red light means a device has been already paired and it is required to delete it for
pairing a new device. To delete a device, press and hold the VALET button for 3 seconds (4 orange
flashes of the LED, or 3 sound signals of the Siren). The system will be in pairing mode for 1 minute.
After a minute or immediately after pairing a device, the system will automatically enter the
programming level №0.
PAIRING RADIO TAGS BT760/BT770/BT780
• Enter the programing level №10.1.1…3.
• If the LED is green, the system is ready for pairing.