Name: Pandora Smart
Brand: Pandora
Rating: 5 (1 reviews)

To Next Page

To Previous Page

USER MANUALPANDORA SMART V3

Online service

button on the control panel.

Mobile application Pandora Connect

Open the mobile application. When the system is online (there is an Internet or Bluetooth connection),

press and hold the

button on the control panel until the scale is fully loaded.

HandsFree mode

Move toward the vehicle with an authorization device

VALET button

Enter the «Secret PIN-code» (see the «Emergency disarming using the VALET button» section).

Locking/unlocking doors when ignition is on

The system allows you to lock and unlock doors when ignition is on. To do this, use one of the

methods described below.

Mobile application Pandora Connect

Open the mobile application. When the system is online (you are in the radio coverage area), press and

hold the

button to lock doors or the button to unlock doors on the control panel until the scale

is fully loaded.

Automatic modes

There are automatic lock modes that will lock the doors at the car movement or on switching on the

ignition. When using doors locking mode on car movement start, the system will detect car moving

and perform doors locking (it depends on speed status in a digital CAN-bus or motion sensor sensitivity

settings). When using doors locking mode on switching on the ignition, the doors will be locked

automatically 5 seconds after the ignition was switched on. If any door was opened after the ignition

had been switched on, automatic locking will be disabled to prevent locking the keys inside the car.

Doors can be automatically unlocked when the ignition is switched off.

These modes are disabled by defaulT, use The pandora alarm sTudio To enable These seTTings.

PANIC mode

If your car or you are in danger and you want to draw attention to your car, you can use PANIC mode.

In this mode the siren will sound

and turn signals will flash repeatedly for 30 seconds. To

activate this mode, use one of the methods described below.

Mobile application Pandora Connect

Open the mobile application. When the system is online (there is an Internet or Bluetooth connection),

press and hold the

button on the control panel until the scale is fully loaded. To switch this function

off press and hold the

button on the control panel until the scale is fully loaded.

Questions and Answers:

Need help?

Do you have a question about the Pandora Smart and is the answer not in the manual?

Pandora Smart Specifications

General