CRAC/CRAH Sensor Hardware Installation Manual
- 5 -
l Appendix C – Technical Support: Describes the process for contacting Technical
Support, opening a Support Case, and the Return Material Authorization (RMA)
process
Document Conventions
"Table 2 – Installation Guide Style Conventions" below defines the style conventions
used throughout this document.
Table 2 – Installation Guide Style Conventions
Item Description
Bold Used for anything a user types, clicks, presses, or taps For example, Click OK.
NOTE: Exceptions to the rule and other important information
Denotes a warning
Denotes a safety warning of a physical or electrical nature
Document References
The documents listed in this section affect the activities in this document. Refer to the
appropriate document for user-specific information.
l SynapSense Software Installation Guide
l Web Console™ User Guide
l MapSense™ User Guide
l Active Control™ User Guide
Warnings and Precautions
The following warnings and precautions pertain to the CRAC/CRAH sensor installation.
Failure to adhere to warnings and precautions could result in physical injury or damage
to equipment, which may void the warranty.
Warning: When performing subfloor work in a data center, be careful not to
stress, crush, pull, or disconnect wiring and hoses running underneath electrical
and data cables, leak detectors, etc. (including fire alarm/suppression systems).
Warning: Subfloor work poses significant trip/fall hazards and eye hazards from
airflow-borne debris. Eye protection must be worn at all times when removing or
replacing floor tiles and when working in or around areas with removed tiles.
To Next Page
Loading...