• Set the correct label size.
• Press [MENU] → [Setting] → [Shift X]
to fine tune the parameter of Shift X.
• Set the correct label size.
• Press [MENU] → [Setting] → [Shift Y]
to fine tune the parameter of Shift Y.
6. Maintenance
This session presents the methods to maintain your printer.
• For Cleaning
Depending on the media used, the printer may accumulate residues (media dust, adhesives,
etc.) as a by-product of normal printing. To maintain the best printing quality, you should
remove these residues by cleaning the printer periodically. Regularly clean the print head and
supply sensors once you change to a new media to keep the printer at the optimized
performance and extend printer life.
• For Disinfecting
Sanitize your printer to protect yourself and others and can help prevent the spread of viruses.
• Important
- Set the printer power switch to O (Off) prior to performing any cleaning or disinfecting
tasks. Leave the power cord connected to keep the printer grounded and to reduce the risk
of electrostatic damage.
- Do not wear rings or other metallic objects while cleaning any interior area of the printer.
- Use only the cleaning agents recommended in this document. Use of other agents may
damage the printer and void its warranty.
- Do not spray or drip liquid cleaning solutions directly into the printer. Apply the solution on
a clean lint-free cloth and then apply the dampened cloth to the printer.
To Next Page
Loading...
