Panorama plus - Power on Indicator; Wait Indicator (Warm Up); Diagnostic Indicator

4-2 Operator Panel and Indicators
4.3 Power On Indicator
Lights when the scanner is ON and is receiving power.
4.4 Wait Indicator (Warm Up)
Lights when the scanner power is turned on, and stays on during the
internal diagnostic and stabilization phase. Keyboard input is
prevented during this time.
The Wait Indicator Flashes if auto-adjustment of the scanner's light
profile, stitching etc., has been suspended for about two hours. This
may happen when operating the scanner in "Extended Thickness"
mode over an longer period of time. In these cases, the Original
Pressure Platen should be returned to the NORMAL position for a
short while to trigger the scanner’s auto-adjustment routine.
4.5 Diagnostic Indicator.
Flashes if an error is detected by the built-in diagnostic. Simultaneous
flashing by both the "Diagnostic" and the "Wait (Warmup)" indicators
may mean that the scanning area needs cleaning.
See Chapter the "Maintenance" for instructions on cleaning the
scanning area.
D
D
F
E