II
Table of Contents
1. Introduction 1-1
2. System Overview 2-1
2.1 Scanning and Copying Software 2-3
3. Operating Modes 3-1
3.1 Graytone Mode 3-1
3.2 B/W Copy Modes 3-1
3.3 Dual 2-D Adaptive Enhancement & Thresholding 3-2
3.4 B/W Modes 3-2
3.5 2D-Sharpening, 2D-Softening and 2D-Blur 3-3
3.6 Resolution and Scan Width in all modes 3-3
4. Operator Panel and Indicators 4-1
4.1 Paper Feed/Forward Key & Ready indicator 4-1
4.2 Paper Reverse Key 4-1
4.3 Power On Indicator 4-2
4.4 Wait Indicator (Warm Up) 4-2
4.5 Diagnostic Indicator. 4-2
5. Original’s Insertion Slot 5-1
5.1 Rulers 5-1
5.2 Scanning Thick Media 5-3
5.3 Removing the Original Pressure Platen 5-6
6. Installation 6-1
6.1 Set up the scan station 6-1
6.2 Smart Card 6-1
6.3 Install Maintenance software and Drivers 6-1
6.4 Connection through the SCSI interface 6-2
6.4.1 Step 1: Install the SCSI host adapter board 6-3
6.4.2 Step 2: Install the SCSI driver software 6-3
6.4.3 Step 3: Connect the scanner to the PC 6-3
6.4.4 Step 4: Set the scanner DIL-switches 6-4
6.5 Installation Verification 6-8
6.6 Preliminary Maintenance 6-9
7. Maintenance 7-1
7.1 Cleaning the Scan Area 7-1
7.2 Camera Alignment 7-4
7.3 Calibrate the Scanner 7-7
8. Appendix A: PANORAMA specifications 8-1
9. Appendix B: Regulations 9-1
To Next Page
Loading...