2.7 Idle Running of the machine
At the time of machine dispatch, speed and feed levers are set for
the lowest value. You are requested to ensure that these position are
maintained at the time of starting the machine to avoid accidental
switching on at high speed and feed, which may damage the machine.
Machine saddle, tail stock spindle etc, are kept locked at the time
of machine dispatch. Do not try move them until they are properly
cleaned, lubricated and unlocked. Before starting the machine study
machine control as illustrated.
Ensure you know how to start/stop the machine before starting the
machine.
For option 2.5.1 or 2.5.2
In case of machine having only Reverse / Forward switch (8
spindle speed) or machine having speed selector switch and reverse
forward switch (16 spindle speed), machine can be start or stop by
reverse forward switch.
For option 2.5.3 or 2.5.4
In case of machine having third shaft and control panel box to start
machine first put on/off switch (60) given at head stock leg in on
position than turn power-on key given in control panel (59) and then
machine can be start by reverse forward handle (25). This lever have 3
positions, center position is neutral position. On either side, one position
is reverse and other position is forward. To engage any one position,
first this lever should press toward head stock side and than it can be
rotate to desire position.
Machine can be stop by pressing foot pedal or foot brake (57) or
machine can be stop by pressing emergency stop push button given on
control panel (59). For again re-start the machine, reverse – forward
handle (25) should bring in neutral center position and again engage in
desire position.
PANTHER
MODEL PAGE NO.
1350 / 1650 23
To Next Page