Section 3
OPERATIONS.
3.1 Safety
(1) Protect you eyes by wearing safety glasses.
(2) Wear shoes with oil resistance soles.
(3) If you have long hair, tie it back properly.
(4) Do not wear long sleeved clothes or loose clothing.
(5) Make sure that your work area should be free from chips,
coolant, Elect. Wire, air-hoses, oils or any thing that can be get
in your way and cause you to fall.
(6) Make sure that work holding are firm.
(7) Make sure that tool holding are firm.
(8) Ensure proper belt tension.
(9) Refit covers and guards before the machine is put again into
operation after opening of any cover or guards.
(10) Do not file work piece, when they are being rotate under power.
This is extremely hazardous.
(11) Do not touch machine part immediately after machining, It may
have sharp edges and considerable amount of heat.
(12) Wear rubber sole shoes while working on electrical cabinet.
(13) All maintenance work should be done with power off condition.
(14) Electrical shock can cause serious injury or loss of life. All
service and maintenance work within the electrical cabinet
should be performed by qualified electrician in power off
condition.
(15) When replacing fuse always replace them with the same type
and rating. Do not substitute fuses for higher current or
different voltage.
(16) While working on the machine parts like brake unit,
transformer etc, it may be extremely hot. Take sufficient care
when handling such parts.
(17) Do not shift gear in the running condition in headstock as well
as Norton gearbox.
PANTHER
MODEL PAGE NO.
1350 / 1650 24
To Next Page