Pantum M7100DW Series User Manual

10.3.1.2 Manual fax sending
1)
Put an original on the glass platen or into the ADF (please see Chapter 2.5 for how to put
an original).
2)
Press the Fax button and use the number buttons to enter the Fax number.
3)
Press “Speaker” or pick up the receiver to input the fax number.
4)
After hearing the fax prompt, press “Start” to confirm sending.
·
If the
party called
receives the
call, you
may have a voice
communication; after confirming
the fax sending and hearing the fax prompt, press “Start” to begin sending.
You have two ways to receive Fax, and the default for the printer is Fax mode.
Telephone mode: determine each call from the calling party as a call. With this mode, you may
need to pick up the receiver manually and then press “Start” on control panel to receive the fax.
5)
After all scanning complete, activate the fax to send.
Note: · In order to prevent damage to this product, do not use a manuscript with
correction tape, correction fluid, paper clips or staples on it. In addition, do
not load photos, small manuscripts or brittle manuscripts into the
automatic document feeder.
10.3.2. Receive Fax
Fax mode: determine each call from the calling party as a fax. When arriving the ring count set,
it gives fax receiving signals and receives the fax automatically.
101

Pantum M7100DW Series Specifications

General

Print Technology	Monochrome Laser
Print Resolution	1200 x 1200 dpi
Connectivity	USB 2.0, Ethernet, Wi-Fi
Duplex Printing	Automatic
Input Capacity	250 sheets
Scanner Type	Flatbed, ADF
Processor	600 MHz
Memory	256 MB
Recommended Monthly Page Volume	750 to 3, 500 pages
Scan Resolution	Up to 1200 x 1200 dpi
Copy Resolution	600 x 600 dpi
Operating Systems	Windows, macOS, Linux
Monthly Duty Cycle	60, 000 pages
Output Capacity	150 sheets
ADF Capacity	50 pages
Media Sizes	A4, A5, A6, Letter, Legal
Media Weight	60-163 g/m²
Mobile Printing	Pantum App, Apple AirPrint, Mopria
Print Speed	33 ppm (A4) / 35 ppm (Letter)
Copy Speed	33 cpm (A4) / 35 cpm (Letter)