35
5. Wireless network setup (applicable to Wi-Fi
models)
Depending on model, the printer with Wi-Fi printing function supports the two types of wireless
network connection of both infrastructure connection mode and Soft-AP, while there is usually only
one connection between computer and printer at a time. If you have problems during wireless
network setup, please refer to Section 5.3 Wireless Network Setup Frequently Asked Questions.
Basic structure mode: connecting to a wireless device via router
1. Access point (wireless router)
2. Wireless network printer
3. Computer connecting to access point via wireless network
4. Computer connecting to access point via network cable
Soft-AP
The wireless computer is directly connected to the wireless device.
5.1. Basic structure mode
You can connect a computer to your printer via access point (wireless router) as the medium.
Important: Before wireless network installation, you must learn about the service set identifier
(SSID) and password of your access point in order to use them during wireless network setup. If
they cannot be determined, please consult your network administrator or access point (wireless
router) manufacturer.
5.1.1. Wireless network setup tools
If your computer has been installed with a driver and had been connected to wireless network, but
the wireless network was changed, you can set it again with wireless network setup tools.
5.1.1.1. Preliminary preparations
1. Access point (wireless router).
2. A computer that has been connected to network.
3. A printer that has wireless network function.
To Next Page
Loading...
Need help?
General
