Pantum P2502W Plus User Manual

38
2.2 The computer is not connected to wireless network Input the SSID (case sensitive) and
password of access point (wireless router) in the interface below. Complete configuration according
to interface prompt.
Note:
• If you do not know the SSID of access point (wireless router), please click “Print
Wireless Network Information Page” to view the SSID of the needed access point
(wireless router).
• If the printer cannot be used normally after wireless network setup is finished, please
install the drive again.
5.2. Wi-Fi hotspot mode
You can establish a connection between a wireless network-enabled computer and a wireless
network-enabled printer without using an access point (wireless route).
5.2.1. Preliminary preparations
1. Printer with Wi-Fi hotspot function.
2. Computer with wireless network function.
5.2.2. Wi-Fi Hot Connection
Before connecting the printer hotspot, enable the Wi-Fi hotspot function of the printer by tapping the
"Wi-Fi" button on the printer panel.
Note:
• Tap the "Wi-Fi" button on the printer panel, and the printer will automatically print the
"Mobile device Wi-Fi connection guide page" for Wi-Fi connection of a mobile device.

Pantum P2502W Plus Specifications

General

Print Technology	Monochrome Laser
Print Speed	22 ppm
Print Resolution	1200 x 1200 dpi
Maximum Monthly Duty Cycle	15, 000 pages
Processor Speed	600 MHz
Memory	128 MB
Connectivity	USB 2.0, Wi-Fi
Wireless	Yes
Paper Input Capacity	150 sheets
Paper Output Capacity	100 sheets
Duplex Printing	Manual
Supported Operating Systems	Windows, macOS, Linux
Media Sizes Supported	A4, Letter, Legal
Media Types Supported	Plain, Thick, Label, Envelope, Thin
Dimensions	337 x 220 x 178 mm
Power Consumption	Average 370W, Sleep 2.0W