cod.
97845
Once the machine has been set up properly, start the engine as follow:
1. Attention: When the
brush
cutter
is
used and started
for
the
very
first
time, the final
user
is
warmly
recommended
to
push
the
primer
pump
for
10 times at least,
so
has
to
obtain the best
performance
of
the equipment
for
future use as well.
2.
Turn
the engine switch
to
the
ON
position.
3.
Put the choke lever on the A (OFF) I ' I position
4.
Pull the recoil starter handle 3-5times to start the engine, as following picture.
It needs to be hold the throttle trigger when starting.
5.
Adjust the choke lever to B (half open)I + I position.
37
To Next Page
Loading...
