Need help?Do you have a question about the Paragon DTC 600 series and is the answer not in the manual?
General| Manufacturer | Paragon |
|---|---|
| Output Type | Relay, SSR, Analog |
| Control Algorithm | PID |
| Type | Controller |
| Input Type | Thermocouple, RTD |
| Communication | RS-485 |
| Power Supply | 100-240 VAC |
| Operating Temperature | 0°C to 50°C |
| Series | DTC 600 series |
Troubleshooting when the controller display remains blank and no heat is generated in the kiln.
Diagnosing why the controller display is active but the kiln fails to produce heat.
Addressing issues with slow heating performance or the kiln's inability to reach target temperatures.
Correcting inaccurate temperature readings displayed by the kiln controller.
Understanding PF or ErrP errors that occur during the firing cycle, often related to power interruptions.
Troubleshooting the 'FAIL' error message, typically associated with thermocouple connection issues.
Resetting the controller for 'Err 0' errors, often caused by electrical spikes or noise.
Diagnosing 'Err 1' which indicates slow temperature rise, potentially due to elements or relays.
Understanding 'Err 2' related to over-temperature conditions during a programmed hold segment.
To Next Page
