Need help?Do you have a question about the Paragon DTC 100 series and is the answer not in the manual?
General| Control Mode | PID, On/Off |
|---|---|
| Controller Type | Temperature Controller |
| Input | Thermocouple, RTD |
| Output | Relay, SSR |
| Display | LED |
| Input Voltage | 100-240 VAC |
| Operating Temperature | 0-50°C |
| Storage Temperature | -20°C to 60°C (-4°F to 140°F) |
| Humidity | 35-85% RH |
Ensure correct transformer voltage and wire connections to prevent damage to the controller.
Troubleshoot issues when the controller display remains blank, indicating no power.
Address slow firing or failure to reach target temperatures during a kiln cycle.
Diagnose why circuit breakers or fuses are blowing, indicating an electrical fault.
Resolve inaccurate temperature readings displayed by the controller.
Troubleshoot inconsistent or jumping temperature readings during operation.
Steps to resolve the 'FAIL' error code displayed by the controller.
Diagnose and fix the 'Err 1' code, often related to slow firing.
Troubleshoot 'Err 2' for over-temperature during a hold segment.
Verify power supply voltage to the controller's input terminals.
Check the electrical resistance of heating elements for continuity.
Test relay operation and coil resistance using a 12-volt battery.
To Next Page
